The SMSC connections section of the status only ever show 'connecting'. I am not sure just which parameters need to set in a modem config so, I have hoped that the default would work. For the modems sections of the config file I have simply included the nf file that was installed with Kannel. I believe the connection via MS Hyper Terminal is telnet.
Help to setup kannel as smsc driver#
I did note that the manual says the driver has never been tested in telnet mode. I have set my config file up (I hope) to handle a raw tcp connection. I am not very familiar with all of the terms and protocols in the cell / modem / SMS world yet so I do not understand the implications of turning off PPP and do not know if this is affecting Kannel in some way. I did have to go in and turn off PPP in the modem configuration in order to send via Hyper Terminal. This worked well so I feel confident that I have the IP address and port to communicate with the modem correct. I have been able to connect to the modem and send an SMS via MicroSoft Hyper Terminal. This modem is an ethernet modem and plugs directly into my router. It is a Multitech MTCBA-G-EN-F4 quad-band GPRS modem. I am committed to a modem that I have not seen in any of the discussions to date. Kannel comes up just fine and I can use the http interface to obtain a status of the server but, I am not able to send a message (no receive attempts have been made to date) and it appears that Kannel has not been able to connect to the modem yet. I have also modified the /etc/default/kannel file to start the smsbox instead of the wapbox. I am running on Ubuntu 7.10 with Kannel 1.4.1 loaded via apt-get. I am having some problems and would really appreciate any help I can get. Hi, I am new to Kannel and am trying to set it up to send and receive SMSs.
Is to have direct access to your operator’s SMSC.
Instruction set in order to setup Kannel using a pre-packaged.
0 kommentar(er)
